With the return of high temperatures in the low 80’s and lows in the upper 50’s Williston Crossings’ maintenance crews have been busy pruning trees and bushes, clearing undergrowth, cutting grass, and painting the white light poles at all of the sites in the older/south section of the resort. Many long-term residents have also been busy tending to the landscaping improvements they have made to their sites, including shrubs, flowers, herbs, and grass. With an overnight low of 34 degrees F two nights ago, many residents were also bringing plants inside or trying to cover them up. Even in north central Florida this winter seems determined to extend its influence well into spring.
Paper towel holder installed above kitchen sink behind fluorescent light fixture.
Single-end mounting of paper towel holder.
This morning dawned heavily overcast and the forecast was for rain. No matter; we had our morning coffee, read, worked on e-mails and websites, and finally had breakfast. We had a couple of projects to tend to so we did those next. First we installed the new paper towel holder in the kitchen. We mounted it to the underside of the cabinet over the sink, behind the small fluorescent light fixture. It is convenient to reach, even with wet hands, and definitely off the counter and out if the way.
Very little of the paper towel holder is visible.
Next up was the cover for the Fan-Tastic Vent motor. The manual operation knob slides over a splined shaft on the motor and is retained by a small machine screw. The knob has to be removed to allow the old cover to come off and the new one to go on. It did not come off easily, but I coaxed it off without breaking anything. When the two mounting screws that hold the cover were removed the whole motor assembly just fell out and dangled from the two power wires. The drive shaft is also a splined connection that slips over the lift mechanism shaft and the power wires are attached with insulated spade connectors. This design makes it easy to replace the motor if it fails.
The new motor cover for the Fan-Tastic ven fan in the bedroom. We left the knob off.
The biggest challenge in this little project, besides standing on a dual chamber air mattress to do the work, was simultaneously getting the drive shafts re-engaged, the cover plate holes lined up, and the mounting screws re-installed. All of this alignment is done ‘blind’ as the mating parts are inside the unit where they cannot be seen. But we got it back together without too much swearing. The other difficulty was the walnut trim that surrounds the opening. The way it is constructed it actually interferes with the knob. We decided not to re-install the knob so I put the retaining screw back in the shaft and we stored the knob in one of the small bedroom storage cubbies.
Workers enclosing the rusted iron on the Pullman cars with wood.
The Lazydays RV dealership in Seffner, Florida (just east of Tampa /St. Pete) has been staging units in the new/north section of Williston Crossings RV Resort for the last couple of days. The rain never materialized today and the clouds thinned as the day progressed. We walked over to see any new units they had brought in since we were there yesterday. On the way over I grabbed a couple of photos of the work being done on the old train cars that will eventually be rental cabins. As you can see in these photos, they are reinforcing (encasing) all of the old structural iron, which is heavily rusted, with wood.
A wider view of the restoration work on the Pullman cars.
Lazydays had their entrance structure erected, a tent to shade the sales associates, and tables with chairs where folks could sit and relax. All of the motorhomes were Class A’s and most of them had hitch-mounted telescoping flag poles flying Lazydays flags. There were at least six additional motorhomes and another 5th Wheel trailer. We looked at all of them and I photographed a few “features” that I thought were interesting.
The LazyDays RV display at Williston Crossings RV Resort.
Door latch for side-by-side residential refrigerator doors.
One unit had a residential refrigerator with upper side-by-side doors and a bottom pull out freezer drawer. There was nothing unusual about that; what caught my eye were the aftermarket latches Tiffin had installed to lock the upper doors together and lock the freezer drawer to the surrounding cabinet. Very cool. By evening we heard that both of the 2014 Tiffin Allegro Open Road motorhomes had been sold. I suspect that made the whole “mini-show” worthwhile for Lazydays.
Same latch design used to lock freezer drawer.
The other thing we finally did today was register for the 2014 Escapade, which is back at the Elkhart County 4-H Fairgrounds May 12 – 17. Our first Escapade was there in September 2010 and we were back there for GLAMARAMA13 in September 2013. As I have written in this blog previously, it is an excellent facility for rallies of 500 – 1,000 rigs. We will be back there again in June for GLAMARAMA14.
